Nuestro blog sobre la fibra óptica y el cable de ethernet abrazaderas accesorios
Tension clamps are designed to rigidly fasten the cable to the supports
They are installed at the beginning and end of the line, in the places of its turns, and can also be used in places of increased tensile load on the cable, with a long length of straight sections - for suspension at several intermediate points.Before buying a cable clamp, you should read the recommendations for their selection:
- the loop should be hit by a cable-like one, which compensates for the load from the wind, damage to the cable at the clamping point;
- the teeth of the wedges should not pierce the cable sheath, regardless of the cable design, even if a cable with a cable or steel wire is selected;
Cable clamps are an integral part of a wide range of cable management products
The creation of a fiber-optic communication line will certainly entail the need for such elements as clamps for hanging an optical cable and other cable accessories. However, a lot depends on how the optical cable needs to be installed, what are the conditions in which it will be located, what loads will have to withstand. In any case, it is very important to choose the right cable clamps for fixing it in certain places on the network.Universal supporting сlamp P1 for all types of cable is primarily intended for fastening self-supporting fiber optic cables and is used to avoid excessive cable sag. It consists of a curved steel bar and is equipped with self-adjusting polymer wedges that firmly grip the carrier without damaging the outer insulation of the fiber optic cable
It is imperative to select the correct anchor clamp
It is imperative to select the correct anchor clamp to suit the specific conditions of use, cable diameter and type, as using the wrong anchor clamps can damage the optical fiber.To buy the right mounts for a fiber optic cable, you need to take into account its type and the diameter of its supporting element. For installation, attachment points are also needed, to which clamps and other elements of the installation of cable equipment cling. For fixing to the supports, steel hooks are used. They are fastened with self-tapping screws, bolts or using a bandage tape with clamps. Sometimes hooks are welded to the cross-arms of the supports. Traverses are often used, designed to fasten tension and support clamps when hanging the wire on supports.
Wedge type tension clamp anchor clamp
The optical wire can be carried out using a suspended installation, which is divided according to the method into tension and support. Optical cable suspension fittings for the tensioning method provide for the use of anchor and spiral clamps. Anchoring tension fasteners are mounted on bends, at the beginning and end of the route, as well as at several intermediate points of a straight section of great length, where the cable is significantly stretched.
Fiber-optic cable OKT8
Fiber optic cable is a fundamentally different type of cable compared to other types of electrical or copper cables.Information on it is transmitted not by an electrical signal, but by a light signal. Its main element is transparent fiberglass, through which light travels over huge distances (up to tens of kilometers) with insignificant attenuation.On our site you can find different types of cables.